No, the 125 swing is slimmer and has smaller axle and bearing and different eye positions for the shocks.
Yes It will. There might be a weight and length difference but the pivot point will be the same width.
yes it is as far as i know only thing is it is shorter
Bigger hammer.
On the back of the engine, close to where the swing arm pivot is
with a check swing or a bunt(unless your fast like Carl Crawford or Ichiro Suzuki)
To tighten the chain on this model four wheeler, one must first loosen four bolts located on the swing arm axle. Then rotate the chain counterclockwise, and tighten those bolts back down.
josh hamilton has the fastest bat swing with 110 mph
Loosen the top two bolts on the swing arm, after tighten the two bolts on the rear of the swing arm until you have 1.5"-2" of slack. Tighten the top bolts back up and good to go
It's in behind the center console, near the firewall. If you remove (completely swing down) the glove box you can see the wiring plug needed to get to it.
I believe that it is 36psi in the back and 32psi in the front. On the swing arm there should be a decal that states what the recommended psi is. If not, it should say on the tire.
Swing Brother Swing was created in 1949.