On the 1994 Yamaha Breeze the valve clearance on the intake should be set at 0.006 inches. The valve clearance on the exhaust should be set at .011 inches.
how do i set the timing on a 1985 yamaha 200 3 wheeler
Valve clearance of Volvo f12, are set using a feeler gauge on the lash adjuster.
the valve clearance should be set at .002 for the intake and the exhaust
They are to set @ .005 in
Intake valves are set at 4 thousandths and exhaust set at 6 thousandths.
1990 yz250 2 stroke power valve set up information, adjustment ?
.006" intake .007" exhaust Standard screw and locknut adjusters. Set the clearance when the engine is cold. Be sure to set each valve with cylinder at TDC. (top dead center) I suggest replacing the valve cover rubber gasket when adjustig the valves, as they do get old and can crack/leak.
Does it run on choke? Is it starving for fuel, if so is the needle valve set for the float?
The Proton Savvy 1.2 engine valve clearance is typically set at 0.20mm for both the intake and exhaust valves. However, it is always best to refer to the specific vehicle's service manual for the accurate valve clearance specification.
Best Yamaha acoustic drum set - Yamaha Phoenix Best Yamaha electronic drum set - Yamaha DTX950K
Take out the spark plugs and turn engine over till the timing mark is tdc in the sight glass. The sight glass is behind the generator cover which can be removed with a phillips head screwdriver. One of the pistons should be at the top when you do this, it will be the one you check first for valve clearance. Valve clearance on older models will be 10mm for intake, 15 mm for exhaust. After you set that piston roll the engine over till the other piston is at top dead center, the timing mark should be on the arrow as well. Now set the valve clearance for that cylinder. After you do this roll the engine over a couple of times and recheck valve clearance on both cylinders to make sure you got it right. That's it! There is no way to set timing on an engine that I know of other than moving the timing chain on the gears.