0
Unlock the helmet lock, bump the seat toward the rear and lift it off. Putting it back on is the same only backwards, but make sure you get the hook under the front of the seat hooked under the crossmember on the frame. Push the seat down and forward, and lock the helmet lock.
Add your answer:
Earn +20 pts
How many spark plugs in Honda v65 magna?
4
How do you change tail light bulb v65 magna?
Remove the seat. Then pull out the black storage bow. You can access the tailight through the hole left.
What is the spark plug gap for 1982 Honda Magna?
Clymer 1982 - 1988 Honda V45 & V65 Magna/Sabre repair manual has 0.031 - 0.035 in.
What type of spark plug does a 1984 Honda v65 magna use?
Ngk dpr8ea-9
What is the horsepower of a Honda v65 magna?
See related link from Cycle Magazine. 105hp
Where can you find a free wiring diagram for a 1984 Honda V65 Magna?
In the back of any repair manual.
What is the Horsepower for Honda V65 magna?
105 horsepower at the rear wheel, as measured by Cycle magazine in 1983.
How do you replace the starter motor on a Honda V65 Magna 1986?
Look in front of the motor,under muffler pipes,there you will find the starter motor.Take two mounting screws out and remove wire.
Where is gas gauge on 1983 Honda magna v65?
There is no gas gauge on the 1983 Honda v65 magna. However this bike will get around 165 miles on a full tank. The best way to know how much fuel you have is to reset the tripometer on the speedometer each time you fill up, and refill at around 160-165 miles.
Where is the turn signal relay on 1983 Honda v65 magna?
The 1983 v65 magna "Winker cancel unit" or "Cancel unit" or "Turn signal Cancel unit" Honda part number 35220-MB4-005 is located inside the fuse box below the headlight, looks like a small black box about half the size of a deck of playing cards.
What is the spark plug cap for a 1983 v65 magna?
.35
Where is fuel pump on 84 Honda v65?
At least for my 83 V65 the fuel pump rests directly beneath the seat and above the pivot for the rear swing arm. Access it from the top, remove the two bolts on either side from the top, disconnect the power, turn off the fuel petcock, and disconnect fuel lines to remove the pump.
