underneath the seat
You need to first pull the flywheel/magneto off of the crank shaft. The starter clutch is attached to the back side of it with bolts.
Mine has 25x13.50-10 super swampers on the rear. I could maybe go a bit taller, but any wider and I'd be rubbing the muffler
Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
Disconnect the battery, and remove the electrical connection and remove the bolts, and reverse to install.
The Battery in a 1993 dodge viper Rt10 is under the truck. You have to remove the spare tire and then about 18 screws to remove the panel and the battery fits underneath. If you need to jump start the vehicle it has a positive terminal on the right side of the engine in a plastic box that opens and then you would use a ground from the engine .
Yamaha Wave Blaster was created in 1993.
34ftlb is the torque for 1993 Yamaha xj600s. I am giving the linkthat will increase the knowledge about bikes.
Remove the air cleaner assembly, and the battery hold down bolt or bolts if you have two. There located on the bottom of the battery. Installation is reverse of removal instructions.
The engine size is Yamaha WR500 in a 1993 waverunner, the engine size is right in the name of the jet ski.
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
it is 1993