answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change crankshaft sensor on 1998 Harley Davidson fat boy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the speed sensor on a 2003 Harley Davidson FLHTCUI?

On the tranny.


Is there a speedometer sensor on a 2000 harley Davidson ultra classic?

If you don't have a speedo cable on your front wheel, you have a speedo sensor. I believe that change was made in 2000.


Where is the sensor for a 95 harley Davidson digital speedometer?

a 95 harley does not use a digital speedometer. If urs has one, it is probably aftermarket modificiation.


How do you change crankshaft sensor in a 2001 Saturn sl?

were is crankshaft sensor located in 2001 Saturn l300


Where is the speedo sensor on a 1998 harley Davidson Dyna Wide Glide Evo engine.?

on the bike somewhere


Where is the speedometer sensor on a 2000 harley Davidson ultra classic located?

on top, right side of trans


Where is the bank angle sensor located on a harley Davidson?

It's under the seat and bolted to the rear fender.


What effects will a bad cam sensor have on a harley Davidson 883 sportster?

wont fire, timing off, backfiring


Where is the speedometer sensor on a 2003 harley Davidson road king?

top right side of the transmission, toward the rear.


How do you change the crankshaft position sensor on a 2003 Nissan Altima?

How do you change the crank sensor on a 2002Nissan Atima3.5?


How do you change the crankshaft sensor for a 2004 crossfire?

Disconnect the negative battery cable.Remove the air cleaner housing.Disconnect the crankshaft position sensor harness connector.Remove the retaining bolt and the crankshaft position sensor.Reverse procedure to reinstall.Are the Crankshaft sensor and the Crank snsor the same?Please let me know?


Where is the crankshaft sensor on 1995 buick regal 3.8l and how do you change it?

The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.