To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
Its under the rider's seat. You have to remove th seat.
you must remove the bolt behind the rear seat and remove the rear seat then you will see 2 small Allen head bolts remove them and the seat will come right off.
You have to remove the Allen bolt on the rear of the passenger seat, then remove the two Allen bolts exposed when you removed the passenger seat. The driver seat should slide back and off now.
Yes, you just need to remove the center bracket (back seat bracket) on your bike
Use your key on the left side by the seat. turn it counterclockwise. and the front seat should pull off. Once you remove the front seat there are two releases to remove the rear seat.
You can remove the off a Suzuki 230 4 wheeler by locating the mounting bracket on the floor of the vehicle. Once you find that, you can remove the screws in the plate with a Phillips head screw driver, and take the seat out.
Remove the two Allen bolts at the rear of the seat with a hex wrench, then slide the seat backwards.
Remove seat. Remove 2 bolts holding gas tank. Lift gas tank and move to right far enough to remove bolts on left side cover to access spark plug.
i own a 87 suzuki savage i would expect it is the same steps there is two screws that hold the seat on there located towards the rear of the drivers seat not the passengers seat after removeing the two screws the seat should lift free there is one screw under the drivers seat that holdes the passenger seat on remove that and push the passenger seat forward and lift
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.