I have a 2003 Honda recon 4 wheeler. I thought I was having float issues with the Carb. I ordered a carb kit. Having the same issues. Problem, when cranking the motor over fuel squirts out of the small brass tubes that lay flat on the bottom of the carb, this is where the air filter would hook up. I have triple checked that the float is shutting off and I am certain that this is not my problem. In order to make it fire and run I have to screw the idle screw? almost all the way in, it will fire and run but it revs up and down, if I give it some throttle then it cuts out and dies, like it is then starving for fuel, I have tried to adjust the only other adjusting needle that is located on the bottom of the carb, it doesn't seem to make any difference where I adjust it? I am wondering if it might be something else besides carb problems? Like valves or whatever??Please help, thank you
What carb? what diagram for what? did you just smoke a big bowl?
How do you set the carb on a 2003 Honda CR125, i have purchased a second hand bike but have no manual.
You can obtain a parts diagram for your 2004 Honda Rancher at most Honda dealerships. The parts diagram can also be found at most auto-parts stores.
Factory carb settings for a 84 Honda 200s
bikebandit.com then click oem parts then select th year then model then select the carb pic and it will enlarge a pic of it!! good luck!
1989 Celebrities are fuel injected, there is no carb.
when you buy a rebuild kit for it it should have instructions, very simple carb to rebuild.
You have wires going to the carb on a 72 Chevy c10?
www.suddco.com
22mm is the float height for this carb
The diagram is in your left sock.
24mm