A long screwdriver is handy when screws are deeply recessed or hard to access (such as in an engine bay reaching through the fan and under the starter motor where big human hands don't reach).
A long screwdriver can be easier to keep on the screw head. Picture a driver being held on a screw head in a wobbly hand where the driver stays on the head but the handle is rotating in an arc. Lets say the driver will slip out of the screw head if the hand wobbles more than 10 degrees off square to the screw head. For a long driver, this may need a wobble of 20mm, but the equivalent arc when using a stubby driver might result from only 5mm movement of the handle, needing a steadier hand.
Wiki User
β 15y agoit is cheap, (as long as you don't mind the pollution... )
There is an advantage to using Orbitz car rental service as long as you are a member of their program. If you are, you will build up points, ultimately leading to a free rental.
Every screwdriver has a handle. You hold the handle and turn it to tighten or loosen a screw. Sometimes your screw might be in a tight place that your hand can't get to such as inside of a car hood. You use a long reach screwdriver because the shaft above the handle is larger than a typical screwdriver. A typical screwdriver shaft is about 5 inches. A long reach screwdriver is bigger. Maybe 12 inches or 2 feet long. It's just a long screwdriver. I can't believe you would as this question
i think a screw into a board a long screwdriver with a narrow handle
Using a Long screwdriver and bright light, find the retaining spring through front grille and release it.
As opposed to radio, laser is highly focused. Meaning that as long as you can keep the beam aimed at the receiver, it's easier to prevent others from learning whats being transmitted
whats a cabal :S whats a cabal :S
It's free.It's clean, with no harmful emissions.It's renewable; it will still be there as long as the sun exists.
There are two small holes in the butt pad of the stock. Lubricate a Phillips head screwdriver into the holes and remove the butt pad. Using a long flathead screwdriver remove the screw in the center of the stock. To add new stock simply reverse.
whats a foopet
A really long prison!
1cm long or 9m long