0
Add your answer:
Earn +20 pts
What are three types of drill bits?
Hss drill bits, Titanium coated drill bits and brad point drill bits.
What is the difference between a quarter inch drill and a three eighths inch drill?
The 3/8 drill is one eighth larger.
What angle drill bit do you use in a lathe?
Low angle makes it three drill lock system.
Is it possible three nos of computer in networking through one hub through cat-6 cable?
yes
What type of drill press chuck should be used with a straight shank twist drill?
A three jaw chuck is usual.
How do you drill out the lock of a file cabinet?
Start with a small bit, about 1/4 inch. Drill all of the way through. Move up one bit size and enlarge the hole. It may take three or for bit changes for the lock to come apart.
What size drill bit for a three quarter tap?
2,3mm
Is it possible to get a three month pregnant woman pregnant through intercouse?
No, she is already pregnant.
How do you i run my amp power wire through my engine bay in my 1997 galant?
If I am understanding the question right you would have two or three different options to do so. You could drill a whole through the fire wall. You can attach(often with tie straps) the wire through the bottom and you could drill a whole under the car. Lastly you can do a combination of the above two and use a tire well or another area of the car to drill through. Which method to use should be decided by ability level and means available to you, also the amount of "professionalism" your system has.
How long does it take to drill a water well?
It depends on the drill you use. With diamond drills it can be done in less than two days, but with a cheap, blunt drill, it could take over three weeks.
Can you get through law school in less than 3 years?
It is possible to get through law school in less than three years, but it requires a full load in the summer.
Can you drill a hole in a cast iron sink and update to a single handle modern faucet?
Most kitchen cast iron sinks have 3 holes and a single handle uses all three. A bathroom sink will have two or three depending on age and if you are very careful and take your time, you can drill a center hole in cast iron. Start with a small pilot hole in the center from the underneath side. You can't start on top on the porcelain. Once you get the pilot hole through, you can then drill from the top down and should use oil to keep the chipping of the porcelain to a minimum.
