Not in its body but in its "hardware stomach" the reticulum. In short, yes. Hardware disease can result with metal in the reticulum; Hardware disease happens when a sharp foreign object such as wire or a nail penetrates the gut lining, resulting in infection as the bacteria from the digestive tract gets into this wound in the gut. The only way to prevent this is to orally insert a strong magnet into the cow's stomach to collect the metal that has collected there and keep the metal away from the stomach lining. The magnet is in the stomach throughout the cow's life.
To prevent any hardware disease or any cattle swallowing any pieces of metal it is best to go through the pasture on walks and pick up any nails, pieces of wire, or any other scrap of metal that the animals could swallow. Purchasing hay with no metal in it helps too.
A cow magnet typically remains in a cow's stomach for the duration of its life. It is not typically removed or expelled from the cow's body. The magnet works by attracting and collecting any metal objects the cow may ingest, preventing them from causing harm.
The largest organ in a cow's body is the liver. It plays a vital role in digestion, metabolism, and detoxification within the cow's body.
Cow sheds are usually made out of scrap lumber and metal and brick.
Most cow bells were (and are) made from metal, not wood. Sounds from metal travels a lot farther than sounds from wood. But basically, a wooden cow bell serves the same purpose as metal cow bells: for a farmer to easily locate where the cow went, since most cows in the mountain regions are never confined to fenced areas.
cow fur or the hair on a cow's body
Cow urine is a boon for humanity actually not bad. Cow urine contains various elements which are present in our body and required by our body.
One cow contains such a minute amount of the world's water that it is considered insignificant.
you got it the other way round, the corn makes the cow
Cock a doodle moo
The exact same way that a normal magnet attracts metal.
You can't. It doesn't matter which end of a cow magnet is North or South. As long as it can pick up metal and the metal sticks to it, then it works just fine.
Yes sculpt out a terminator body then change it to metal give it a airsoft gun. and walla ther you got it