TP isolator means triple Pole Isolator.
The main difference between the two is that a TP isolator is only a "triple pole" isolator. A TPN isolator is a "triple pole" and neutral isolator.
Isolator - EP - was created on 2006-09-26.
The Oscillation Isolator was created in 2018. It is a device designed to reduce vibrations in mechanical systems.
If I'm interpreting the question accurately, a "line isolator" is an insulating standoff for transmission or distribution cable. A bus isolator is an insulating standoff for tubular or bar bus as is normally seen in a substation switching yard.
One cannot build a battery isolator. However, one may rewire a battery isolator. The plans to do that can be found on do it yourself sites such as DoItYourself.
take the wire from the alternator (battery) side, not starter side. Connect to center bolt of isolator and a battery to each of the other bolts, depending on how many batteries the isolator is set up to charge.
Isolator is something which blocks current or heat. Where as Circulator is something through which heat and electricity can pass.
An isolator that is related to optics is called an optic isolator. This is a component that will allow light to only be transmitted in one direction.
You can't. You need a 6 pole isolator
An isolator may burn due to overloading, poor maintenance, loose connections, or faulty components. Excessive current passing through the isolator can cause it to heat up and eventually burn out. It is important to regularly inspect isolators and ensure they are well-maintained to prevent such failures.
For an 11kW 3 phase motor, you would typically need a isolator with a current rating of at least 18-20 amps per phase. It's important to also consider the starting current of the motor and select an isolator that can handle the motor's inrush current. Make sure to consult with a qualified electrician to determine the appropriate isolator size for your specific application.