The red ring of fire. Your x-box is dead or needs to be fixed.
3-4 seconds, give or take 1. 2.53 seconds to flashing railway lights
The bus stops flashing its red light and (if applicable) withdraws its stop sign.
Flashing red traffic lights indicate that drivers must come to a complete stop before proceeding through the intersection. This usually occurs when the traffic signal is malfunctioning or during off-peak hours to manage traffic flow. Drivers should treat a flashing red light like a stop sign.
Hi, I have the PS3 guitar hero world tour and had the same problem, the 2 lights on were number 3 and 4, meaning that the guitar was being setup by the system as the controller number 7, press and hold the PS button to set your guitar to controller number 1.
Flashing red lights may be permanent or temporary (e.g. when the programmed sequence fails).A flashing red light means STOP, then proceed when safe.If it is a 4-way flashing red, cross traffic will also stop, and the intersection becomes identical to one with stop signs. This is a safety feature in some programmed signals. If only one direction has the flashing red (such as a road that intersects a busy highway), the traffic entering the highway must stop, and never has the right-of-way.* Some international traffic signals use a flashing red in place of steady red, to attract the attention of drivers where there is a profusion of commercial lights.
Check the gear switch it is located on the dashboard. You should have it set to auto; if it is set to Hi or Lo the gear light will be on. --------------------------------------------- actually , if the lights are flashing a malfunction has been detected , get it checked out
No
this answer is for a wireless controller. there is a button to the left of where you plug in wired controllers. you click that button and the power button of your xbox will start blinking. then you take your wireless controller and there is a small button above the box where you put the batteries in that you have to click and wait until your controller stops flashing and shows that either player 1, 2, 3, or 4 is connected.
the ayc light
1. Make sure that both the Hover Assault and the controller are off. 2. Open the wire lid on the controller to reveal the charging wire. 3. Plug the wire into the vehicle. 4. Turn the controller to charging mode by sliding the power button all the way down. You should see the red light on the controller flashing. This means it is charging. Charge it until you see the green light and the red light flashing at the same time. That means it is done. NOTE: Leave about 10-15 minutes between playing and charging time to cool down the battery. It is okay if you do it once or twice though by accident.
Yes it can be played with a controller. it can also be played with Kinect. I have been playing it with a controller forever.