0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What fluid goes in a torque conyerter And how much?
The torque convertor uses transmission fluid and is filled by the transmission's internal pump. When you start out with a new convertor, it's a good idea to put a quart of fluid in before installing it on the transmission. When the transmission dipstick shows full, the convertor is also full. An empty torque convertor holds several quarts, depending on the size.
Is there a drain plug on a 1998 Hyundai Tiburon torque convertor?
No, there is not.
How do you align a new torque converter on a 1993 Corolla to the drive plate?
It is easier to do if you install the torque convertor to the transmission and then attempt to bolt it to the flywheel. You will have to turn the convertor or flywheel to line up the bolt holes.
Pontiac Grand Prix stalls when cold?
test the temp sensor. Check spark plugs,plug wires,torque convertor. test the temp sensor. Check spark plugs,plug wires,torque convertor.
92 vigor im having your transmission rebuilt your mechanic says that you also have to have the tur converter replaced What is that?
The torque convertor acts as an automatic clutch for the transmission. If you are replacing the transmission, I would recommend replacing the convertor too, especially if the trans fluid is burnt or contaminated. If you have a manual transmission, run, there is no torque convertor :)
Where is the torque convertor on a 91 Ford Taurus?
Rear end of the engine - front end of the transmission
Is draining the transmission the same as flushing it?
no there is still fluid in the torque convertor,lines & cooling tank
What is fluid capacity of a TH 350 with torque convertor?
10 to 10 1/2 qts.
How do you replace a torque convertor lock up solenoid?
UNPLUG IT! I DID & HAVE HAD NO PROBLEMS YET & THAT WAS A YEAR AGO!!
Will I have to change the heads on your 350 engine to change the cam shaft from a 260 to a 282?
NO. There is no reason to remove the heads are to do any valve spring changing on that size of cam. You may find it helpful to get a different torque convertor to compliment the new cam. Convertor manufacturers can be very helpful in suggesting the right combination for your application.
Do you torque the flex plate to convertor on c4 automatic transmission?
All fasteners have a torque spec suggested by the manufacturer. You will find that information in the shop manual for the vehicle.
How can you tell if a torque convertor is going bad on a 2004 Chevy blazer?
How can I tell if a 1995 torque converter is going bad the tranny slips and stops when it warms up.
