0
Add your answer:
Earn +20 pts
What is CRO and AFO?
Audio Frequency Oscilloscope and Cathode Ray Oscilloscope
A device used to electronically show the crest and trough of sounds?
An oscilloscope is a device used to electronically display the crest and trough of sound waves as visual representations. It shows the waveform of the sound signal as it changes over time, helping in the analysis and troubleshooting of audio signals.
What does the blue wire mean in audio?
The blue wire in audio connections typically represents the left channel for stereo audio signals. In professional audio setups, a standard color code is often followed where blue is assigned to the left channel, red to the right channel, and black or white to the ground.
Can you build an oscilloscope using a computer monitor?
Yes you can. You need to build the oscilloscope circuits and interface them with your PC via parallel/serial/USB Port. Plus Build a program to get the data coming from the port and display it on the monitor.You can use your computer soundcard to view audio frequency signals (20Hz - 20KHz, sound card dependent) using software you can download from the web.WARNING - You can severely damage your soundcard if you exceed the input voltage range! Be sure to use a circuit to limit the input voltage to 1-volt and proceed with caution!
What is oscilloscope in sound waves?
An oscilloscope is a device used to visualize sound waves as they are being produced. It displays the waveform of the sound signal graphically, allowing users to see the shape, frequency, and amplitude of the sound wave in real-time. This can be helpful for analyzing and troubleshooting audio signals in fields such as music production, acoustics, and telecommunications.
What Technique is used 2 transmit audio signals of television?
what is the modulation used in telivision for audio signals
What is a vectorscope?
A vectorscope is a special type of oscilloscope used in both audio and video applications
Why is an oscilloscope used to measure sound waves?
An oscilloscope is used to measure sound waves because it can visually represent the waveforms of sound signals in real-time. This allows for precise measurements of characteristics such as frequency, amplitude, and waveform shape, which are essential in analyzing and troubleshooting audio systems and equipment. Additionally, an oscilloscope can provide a visual representation that helps in identifying distortions or anomalies in the sound wave.
Can a Plasma withouy a monitor input be used as a PC monitor?
Almost all plasma televisions have video inputs. Often, component inputs can also be used as analog RGB inputs. The manual will always describe the type of inputs that can be accepted. A connector with VGA at one end to the appropriate connection at the display will be needed if the display supports analog RGB. HDMI inputs are also available on virtually all modern plasma displays. HDMI is compatible with DVI signals - the digital display interface being used on more and more PCs. If the PC does not have a DVI input, display cards are available at a low cost to be installed in desktop computers. A DVI to HDMI lead will be required. Once again, check the manual to establish which display resolutions are compatible with the monitor. Try to use the resolution that is the same as the display's native resolution. Note that HDMI supports audio on the connector but DVI is video only. If audio is needed, look for an analog audio input linked to the HDMI input. Most displays will have analog audio to support the use of DVI signals with separate audio signals.
What is trunk line?
A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to. A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to.
What is a trunk line?
A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to. A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to.
How are audio signals passed through a matrix?
Audio signals can be passed through a matrix by routing them from input channels to output channels using a combination of switches and controls. The matrix allows for flexible routing and mixing of audio signals to different destinations, enabling complex audio setups and configurations to be easily managed.
