0
1. Shut-down power to compactor unit. 2. Remove the trash bin. 3. Remove four plastic "button" in floor of unit to expose screw-driver access holes. (One hole at each corner of the floor of compacting cavity.) 4. Use medium size, flat blade screw-driver to retract the leveling screws until the pads touch the bottom of the unit. This action lowers the unit and should make it free to "rock back-and-forth". 5. Once free to move, it can simply slide forward from beneath the sink. Protect the floor because the sliding unit can damage the surface.
Add your answer:
Earn +20 pts
How do insert compactor bag in GE compactall trash compactor?
For the GE "Compactall" compactors with the round trash bin: Open the compactor door and look down at the top of the plastic bin. You will see a round silver "retaining ring" with a latch on it and a folding handle. To remove the plastic compacting bin, lift the handle up and pull the bin up until it stops. Then pull straight out, toward you. Flip the latch open and remove the ring. You can lay it aside and now pull the trash bag out of the bin. When putting a new trash or compactor bag in, make sure to allow four or five inches of the bag to overlap outside the top of the container. Take the silver colored retaining band, holding it open, and place it over the top of the trash bag and down on the bin. Push down until it rest on the plastic lip of the container. Flip the latch closed. To replace the bin (it can be a little tricky) make sure the upper retaining ring is on and tight. Place the hooks on the upper and lower retaining rings onto the mounting bracket on the inside of the door of the compactor. Once you are sure both hooks are in the slots, push straight down until the bottom of the bucket is resting on the metal stop at the bottom of the door bracket. The compaction bin and trash bag are now secure and ready for operation.
Where can I find a trash compactor?
A trash compactor will definitely save you some space. If you need lots of space, then I think that the trash compactor will be worth the investment. You can probably find trash compactors at stores like Home Depot, Lowes, or Amazon.
Who invented the trash compactor?
Whirlpool Corporation introduced the consumer trash compactor in 1969, calling it the "Trash Masher." One cannot actually say Whirlpool invented the trash compactor, per se, as commercial units had been around for years. However, Whirlpool was the first to make a compactor that was suitable for consumers as a household appliance.
How do you find a trash compactor that crushes 100 percent to the bottom of the compactor?
You can find a trash compactor that crushes 100 percent to the bottom of the compactor by visiting a local home improvement store. They have a wide variety of models which crush the contents to varies levels depending on the application.
What is the name of the monster that lives in the garbage compactor on the Death Star?
The trash compactor alien is from the Dianoga species .
How does a trash compactor work?
A trash compactor works by compressing the waste material inside using a metal ram. The compacting process reduces the volume of the trash, allowing more waste to be stored in the same space. When the compactor reaches its set limit, it can be emptied by removing the compacted block of trash.
What was the number of the trash compactor in Star Wars?
3263827
Where can I buy a trash compactor?
You can buy a trash compactor from many stores either in store or online. Sears has them and they have a very wide selection. http://www.sears.com/shc/s/s_10153_12605_Appliances_Disposers+%26+Compactors_Compactors
Where can Broan trash compactor bags be purchased online?
The Broan trash compactor bags are able to be purchased at several different online locations such as the following websites: Amazon, the Broan website, and the Repair Clinic.
What are the best things to put into a trash compactor?
The best things to put in trash compactors are non-recyclable items of refuse. Food waste, styrofoam cups, paper bags, and candy bar wrappers are just a few items that can go in a trash compactor.
How to repair a Trash Compactors?
Trash compactors have become a standard feature on many new homes. These useful machines provide a quick and easy way to dispose of food waste, and have become an indispensable part of clean up after dinner. So when something goes wrong with your trash compactor, it has to be fixed quickly. Repairing a trash compactor is a relatively simple task, but it is must be done in a safe and deliberate manner. Typical tools that are needed to repair a trash compactor are wrenches, a multimeter, a screwdriver, a nut driver, and a pad to place on the floor. Any replacement parts for the trash compactor that are needed should also be purchased and prepared prior to beginning the repair work. Once these items have been obtained, the first order of business is to shut off the power to the compactor. This is a crucial safety step, because an energized compactor could cause serious injury to the person repairing the compactor. Once the compactor has been disengaged from its power source, one should also turn off the circuit breaker that supplies power to the compactor. The next step is to remove the compactor from underneath the counter by removing the holding brackets that hold the compactor to the counter. Once the compactor has been removed from under the counter, remove the cover plate and inspect the drive chain, the power screw sprockets, and the drive gear. The cover plate is usually found on either the top or bottom of the compactor. One of two issues are typically found when inspecting the compactor. The first is that the drive chain is broken. In this case, the chain will need to be replaced. Replacing the chain is accomplished by loosening the chain. Loosen the mount bolts and pull the mount toward the sprockets. Once the chain is loose, the chain can be removed and replaced with a good chain. The second potential issue is that the chain is too loose to drive the compactor motor. This issue can be corrected by moving the motor mount away from the chain sprockets in order to increase the tension on the chain. Once the chain has been replaced or tightened, replace the cover plate and install the compactor back under the counter. Connect the compact back to its power source, switch the circuit breaker back on, and test the compactor.
In Star Wars eph 4 who was pulled under that warter?
Luke in the trash compactor
