Although it would be good to have wainscoting tool kit, you can also just cut a scrap of the paneling (about 2inches high by 12 inches long) and rest the cap molding on top. When you make the cut it will be perfect, since this is exactly how it will rest on the wall.
I saw you writing obcenetes along the top of the wall.
The horizontal top of a wood frame wall is typically called the "top plate." It is a horizontal member that runs along the top of the wall framing and helps to distribute the load of the roof or upper floors to the vertical studs below.
Annulet
A top plate is a horizontal framing member that sits at the top of a wall. Its main purpose is to provide a surface for attaching ceiling joists or rafters to create a secure connection between the wall and the roof structure, as well as to help distribute the load of the roof evenly along the top of the wall.
A fractable is something that is used to cover the top of a roof or wall of a building. It generally makes an ornamental silhouette. An example of a sentence would be: "The fractable on the old house was charming".
any carvings at all would be concidered "ornamental";given that ornamental means not necesary to its function.which for church pews that function being to seat the congragetion.
The word is frieze, a word for a sculptured or decorative border, often at the top of a wall along a ceiling.
5 horses
"Usually" the most decorative part of the design is on the bottom.
Start by cutting a small piece of the crown molding preferably about 1 foot. Start by placing the crown molding in the proper position on the ceiling and the wall. Make a small pencil line on On the wall on the bottom of the crown molding Measured the distance from the ceiling to the pencil line And cut a piece of crown molding the same size. Go around the room and mark off the line preferably about 2 to 3 feet apart from each other. Next you need to find the angles of the corners You can do that with a protractor tool that you can purchase at the Home Depot for about $5-$10 Next you need to get your measurements. This will usually require a helper To hold the other end of the tape measure. Measure from wall to wall using the tape measure a simple trick is to make a small pencil line in the centers of the corners to make sure you are measuring at the proper location. It usually helps to write the number on the wall but make sure you put it above the line so you do not need to paint it back Next you need to find your Studs which are commonly known as 2 x 4. With a stud finder you will be able to find the studs easier you can usually purchase one of them at home Home Depot for about $20
....is the top of the foundation wall. Simple as that.