A radiant barrier is a thin sheet of highly reflective aluminum comprised of one or more layers (for puncture and tear resistance) that, when installed properly, will block at least 90% of the radiant heat that hits it.
Radiant barriers are unaffected by humidity or ambient temperatures, unlike other forms of insulation, and therefore perform at a consistent level at all times.
When installed in an attic, a radiant barrier reflective foil insulation products can reduce attic temperatures by up to 30 degrees when installed to the underside of roof rafters. Lowering attic temperatures provides a significant benefit by reducing air conditional loads and energy usage. Attic insulation radiant barriers can also:
Radiant Barrier Definition : Per the Department of Energy (DOE), a product classified as a "radiant barrier" must have a low emittance of 10% or less and high reflectance of 90% or more.
RadiantGUARD®radiant barrier products BLOCK 97% of the radiant heat - much higher than the DOE minimum reflectance criteria for a radiant barrier product.
If you are looking for radiant barrier by the square foot just search online for radiant barrier. I install radiant barrier and it comes from www.ecofoil.com
Radiant barriers can be repaired by using various radiant barrier laminate polyester treatments to become metalized.
First thing to do is read all instructions before installing radiant barrier foil. Make repairs to the area that you are planning to insulate. Unroll the radiant barrier and cut with scissors or knife. Staple into place.
A radiant barrier is typically installed in the attic, either under the roof or on the attic floor, to reduce heat transfer into the living spaces below by reflecting radiant heat. This positioning helps to keep the living areas cooler in hot weather.
There is a need to build a radiant barrier because during a cold winter up to 70-80% of your home or buildings heat can be lost.
You can find this type of insulation at Radiant Barrier Products. 631 Tuten Trl, Orlando, Florida. (407) 382-4737.
The cost of spray-on radiant barrier varies depending on the size of the project and the brand of product used. On average, expect to pay between $0.75 to $1.50 per square foot for professional installation. DIY options may be cheaper but can vary widely in price and effectiveness.
hahahahahahahha, yes
No. A radiant barrier requires an air space to function properly. If the radiant barrier s sandwiched between two solid objects, then the heat will be able to conduct right through it. If you would like to apply a radiant barrier over your existing roof, one solution would be to use spacers or furring strips over the existing roof and use either a tile or metal roof over the spacers. If you must have asphalt shingles, then the radiant barrier would have to be applied in the attic space. A similar issue came up when people wanted to install a radiant barrier under concrete where it would have any air space. In a letter to a manufacturer, the FTC wrote, "It is well accepted that reflective insulation and radiant barrier products must have an air space adjacent to the reflective material to be effective." I am including a link to this letter below. http:/www.rimainternational.org/pdf/ftc-letter.pdf
Radiant barriers are most commonly used in space flight. They protect the spacecraft from thermal radiation while in flight in outerspace.
Radiant Barrier is a term that is most commonly used to describe a kind of material that is used to help save energy by holding in heat and keeping out cold, yet being able to keep out unwanted heat.
Solar screens are woven more losely to allow air to pass through more freely. Therefore they provide slightly less reflectivity of solar heat rays. Depending on where you are wanting to install the product, the radiant barrier will be more effective but I dont know if it will fit your application for sure. I have ECOFOIL radiant barrier installed in my attic and it keeps my air conditioning bill much lower in the summer.