0
Add your answer:
Earn +20 pts
In brochovascular markings which infection we have and what fluid overload?
In bronchovascular markings, infection can be caused by bacteria, viruses, or fungi affecting the lungs. Fluid overload can result from conditions like heart failure, kidney disease, or liver disease, leading to accumulation of fluid in the lungs and pulmonary edema.
In bronchovascular markings which infection we have and what fluid overload?
Bronchovascular markings mean that you have an airway infection or a venous fluid overload.
What is bilateral bronchovascular markings are prominent mean?
Bronchovascular Markings These comprise of 98 % vessels, mainly veins. Respiratory passages are not visible as these contain air. Normal shadows start from hila pass through proximal 1/3rd traverse to middle 1/3rd and just reach the border of distal third. Normaly markings are greatest in the medial part of lower zone. To say whether increased or not basically, in the opinion of Dr Tarar, it is an eyeball technique. With the experience your start saying this is increased or this is normal. Increased Markings This always means either Infection in respiratory passages or fluid overload. Infection may be acute or chronic. If radiologist reports increased bronchovascular markings but clinical situation is not supporting any thing it can be ignored and film should be taken as normal. In cardiac failure cases so called reversal of pattern of markings occur. There is increase in markings in midzones due to fluid overload. Actually this is not reversal. This is only increase in midzones. In chronic bronchitis markings are increased. In emphysema these are decreased in hyperinflated areas. In collapse of the lungs beyond the line-demarcating lung, these must be absent. Source: http://www.pakjfm.com/panelinterview/p9.htm
What is hypertonic fluid overload?
Hypertonic fluid overload is a medical condition in which there is too much fluid in a person's blood. This is caused by an increase of sodium content.
What does mild increase in bronchovascular markings in bilateral mid zones mean?
A mild increase in bronchovascular markings in bilateral mid zones on a chest X-ray may indicate mild inflammation or congestion in the lung tissue. This finding could be seen in conditions like viral infections, bronchitis, or early stages of pneumonia. Further evaluation may be needed to determine the underlying cause.
Is vomiting a sign for fluid overload?
Vomiting can be a sign for a great many things including fluid overload. It can also be a reaction to eating too much food.
What patient is most at risk for fluid overload?
anemick
What happens when iv bag runs instantly?
it will cause you fluid overload.
Is S3 asuculated over the precordium a symptom of fluid overload?
Yes, S3 is commonly associated with fluid overload, as it can indicate impaired ventricular filling from increased blood volume. It is often heard in conditions like heart failure, where there is an excess of fluid in the circulatory system.
Signs of fluid overload?
Signs of fluid overload include swelling in the legs, rapid weight gain, shortness of breath, and elevated blood pressure. Other symptoms may include coughing, low oxygen levels, and difficulty breathing. It is important to seek medical attention if experiencing these symptoms.
What is the function of resilient driving plate of fluid coupling?
resilient plate is used to protect fluid coupling from damages and takes the overload acting on the device ,
Can a ct scan see infection?
shows fluid built up by infection?
