Blanche of Bourbon died in 1361.
Jón Skráveifa died in 1361.
Reginald Brian died on 1361-12-10.
The ka was a chariot
Iska jawab do to Manenge.. 1)1mithai ka naam.? 2)1dawa ka naam.? 3)1film ka naam. 4)1ladki ka naam.? 5) 1city ka naam? 6) 1 car ka naam? 7) 1 Place ka naam? 8) 1 doggy ka naam? koi aisa jawab dijiye jo in 8 ka 1 hi naam ho..??
The short circuit capacity of a BS 1361 60A cartridge fuse is typically around 6000A. This represents the maximum fault current that the fuse can safely interrupt without causing damage or posing a safety hazard. It is important to ensure that the short circuit capacity of the fuse matches or exceeds the available fault current in the circuit where it is being used.
Mine is in the spot numbered 16. Its a 60a fuse, big and yellow...
just pull it out an replace with a new one
There isn't a relay, The fuse is under the hood #6 a 60a fuse and #62 is a 30amp circuitbreaker.
Depends on the fuse, as there are many fuses that comply with BS standards. BS 3036 (re-wirable) and BS 1361/1362 are found in the plugs of many appliances....
Duramax
sb 60a
I t is in the fuse box under the dash board.
10 kW at 220v will use 45.45 Amps. I'd recommend a 60A circuit, with a 60A breaker, but the heater or electric furnace should have "maximum fuse amps" rated on its nameplate. Above all, neverconnect wiring to a breaker that is rated higher than the maximum current capacity of the wire. In the case of 60A, use #6 AWG wire.The HVAC Veteran
There is no reset on the disconnect, you will need to check the fuse's at the disconnect and replace the on that is bad. But most likely if you blew a 60 amp fuse you have a short somewhere, check your termanals at the compressor to see if the compressor went to ground.
1361 is a prime number, and therefore its only factors are one and itself.
We have a 1995 Camry and the fuse box is located on the right handside if you stand in front of the car, you have to unscrew the bolts that hold the fuse box (its the one near the front of the car) and then turn if over you will find that the fuse has wires attached to it the same as the 100amp fuse in the front, then unscrew the bolts that hold the fuse in place and it should just come out by pulling on it. Hope this helps