Wiki User
∙ 14y agoNot just with their feet, but mouth and vagina as well.
Wiki User
∙ 14y agoPreferences and fetishes vary among individuals, and it is not appropriate or accurate to make generalizations about an entire group of people based on race or gender. It is important to approach discussions about relationships and desires with respect and understanding for individual choices and boundaries.
No, the white should be approximately zero and the black approximately 110-120, assuming the "bare ground" refers to a bare conductor attached to electrical ground.
The short answer is wire color to color. black to black, white to white, green or bare to green of bare.
Assuming the wires are the correct gauge for application and breaker you use black and white wires as hot. Put red electrical tape on each end of white wire and connect red and black to the breaker output and bare wire to ground lug in panel. At receptacle connect black and red to hot contacts and bare wire to ground lug.
Yes. Connect Black to Black, White to White and bare ground wires together.
On a 110 volt circuit, Black is hot, White is neutral, Green or bare Copper is ground. . Connect Black to the gold screw, White to the silver screw, and bare copper ground to the Green ground screw on the receptacle. On a 220 Volt circuit Black & Red are both hot, each carrying 110 volts for a total of 220. White is Neutral and ground is Green or bare copper.
Connect the white wire from the European oven to the white wire in the US receptacle. Connect the black wire from the European oven to the black wire in the US receptacle. Connect the green wire from the European oven to the bare wire in the US receptacle. The green wire serves as the ground wire since you don't have a separate ground wire in the US receptacle.
No, when connecting a pull chain switch, typically the black wire is connected to one terminal of the switch, and the white wire is connected to the other terminal. It's important to follow the wiring instructions provided with the switch to ensure proper installation.
In a typical electrical outlet, the bare wire is the ground wire while the white wire is the neutral wire. The ground wire is responsible for providing a safe path for electrical currents in the event of a fault or short circuit. In your specific case, it is possible that the bare wire is acting as a neutral wire, but it is crucial to consult a certified electrician for an accurate assessment and to ensure proper wiring connections.
If you are down stream from the switch then all blacks together, all whites together and all grounds (bare wires) together.
The green or bare wire is typically the ground wire for a dryer plug. If your wires are black, white, and red, the white wire is usually neutral, the black is hot, and the red is also hot. You should double check with a voltage tester to be certain.
You will first need to determine which wire is the hot wire in the ceiling box. Connect the swag kit's two wires to the hot wire and the neutral wire in the ceiling box, leaving the third wire unconnected. Ensure all connections are secure and insulated. You may need to consult a professional electrician if you are unsure about the wiring.
The white wire is typically neutral, the black wire is usually hot or live, the red wire may be a secondary live wire or used for a separate function, and the bare wire is typically the ground wire for safety purposes in an electrical circuit.