0
The reasons that your high beams may not work could be the cause of a few factors. One, be sure to check the fuse that controls the high beams, it is separate from the fuse that controls the low beams. Next, if that doesn't work, go ahead and check the ground wires, a lot of the lighting problems in my VW was the cause of the ground wires. If this doesn''t work for you consider that the high beams could be burned out, but I figure that if both the high beams don't work that isn't the case. Then you would need to take into account the switch located in the steering column that turns the beams on and off is broken. Then if none of the above works you have an electrical short that needs to be fixed the best way to fix this probleem is to replace all the wiring that origionates from the high beams. Iknow this answer is a little long winded but this the way I do it to save the most money in the long run. Good Luck!
Add your answer:
Earn +20 pts
Why wont high beams work high beams work?
First check the bulbs, if the bulbs are good I would suspect the high/low beam switch is bad.
Why wont the low beams on a 2003 KIA Sedona work even after changing lamps when the high beams work fine?
low beam fuse blown.
Why wont the Low beams work on your 2003 impala the high beams work and also the parking lights?
you blew out a fuse under the hood just change it and it should work
How do you run highbeams and fog lights on a 2007 mustang gt?
the fog lights work with the low beams , they wont come on with the high beams
Why wont the daytime running and low beams lights work when I have high beams and have changed both lights and the switch?
Have you checked the drl relay?
Why will my high beams work but my low beams do not on my 1994 Chevy half ton?
Your high beams work but your low beams do not because the switch is broken that switches between high and low beams. Electrical switches wear out.
Your 92 Acura Vigor has low beams that wont work but the high beams do and the parking lights Where would you look for the problem?
first check the bulbs then the curcut then the fuses on the fuse board
Why do the low beams not work and the high beams work on a Mitsubishi Eclipse?
If low beams do not work and the high beams of a Mitsubishi Eclipse do, it is probably due to a corroded connector. Simply clean the connector and add some petroleum jelly to the terminals.
High beams wont work on a 97 escort even though the indicator says they are on also i changed the relay still nothing.?
If the high beams will not work on a 1997 Escort even after the relay was changed, it is possible that the bulbs are burned out. It is rare, but it does happen that both bulbs will burn out at the same time.
Why do turn signal only work when high beams are on?
Take your car in to have it checked. Turn signals should work without high beams.
2000 Chevy Cavalier low beams do not work but day running lights and high beams work what could be wrong?
As a guess both low beams are burnt out The daytime running and high beams are the same light filament. Or the fuse or the relay for the low beams.
Headlights of a 1994 Toyota Camry LE do not work but High beams work what is wrong?
check the bulb low bean burns out before high beams
