0
Add your answer:
Earn +20 pts
Where is the heater fan fuse in the fiat punto?
In a Fiat Punto, the heater fan fuse is actually located in the trim box. This is located right below the steering wheel.
Why does your 1984 CJ7 Screech when you start it?
Loose fan belt.
Why is there a screeching noise when im driving my fiat punto?
good chance the fan belt is slipping when driving may need tightning up this wouold cause a screeching noise.
Why would a 1999 Fiat Punto 60sx Cooling Fan not Come on?
I have the same problem but on Fiat Punto 75sx 1999. please let me know if you slove the problem and will do so if I solve it
How do you adjust a Fiat doblo 1.9jtd fan belt?
HOW How do you FIT A NEW a fiat doblo 1.9jtd fan belt?Read more: How_do_you_adjust_a_fiat_doblo_1.9jtd_fan_belt
Why does your corsa screech on acceleration?
The most likely cause is the fan belt is slipping
What makes my car screech under acceleration?
A lose fan belt is one reason that a car can screech under acceleration. Another reason for the screeching when accelerating could be a problem with the car's timing belt.
What make a car screech?
there is a loose belt probably a fan belt depending on the engine it might be the belt that runs to your alternator either way you need to tighten to make the screetch stop.. Or... It could be your water pump going out. They screech too.
Where is the radiator fan sensor on a mrk 2 fiat punto?
Left hand side of the inlet manifold, identified by a green wire.
Why does my Toyotta Corolla screech intermittently when i accelerate?
intermittant screeching on acceleration is usuall caused by a loose or worn fan belt
Why does car screech when air conditioner is turned on?
you need to tighten your fan belt as it is moving and now slipping on the A/C pulley that you just turned on.
How do you fit a fiat punto 55 fan belt?
WORKING FROM THE FRONT; YOU NEED A SIZE 17 SOCKET ON A TBAR.THE ALTERNATER IS ON DRIVER SIDE AT THE BACK.THERE ARE THREE BOLTS TO LOOSEN (DONT TAKE THEM RIGHT OFF) . PULL THE ALTERNATER TOWARDS THE FRONT OF THE CAR, SLIP BELT OVER CRANK PULLEY THEN OVER ALTERNATER PULLEY .LEVER ALTERNATER BACK TO TIGHTEN BELT,THEN RETIGHTEN 3 BOLTS
