Behind the glove compartment! 4 hex head screws gets you in there then carefully pop the two sheet metal clips down on the left side. Slide the ECM to the left and towards you slightly. Press the wire connector clips down and unplug the two sets of connectors. It's all yours now.
do you have link and program a 88 cilverado ecm when replacing
there is no choke it has idle air control valve it is tbi corect
Yes it will fit. But it will never run. Due to the fuel pump,engine wireing harness, ECM/Engine controll module/computer. To make the 88 V-6 engine run you would need all of this stuff from a 1988 V-6 truck.
cant there is no fitting on these trucks I know ,I have an '88 Gmc Sierra You have to remove the fuel filter and splice one in
i think it is behind the glove box. take the inner part out of the glove box and it should be right there
check your thermostat. it could be sticking.
Yes, it will fit perfectly.
The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.
Inside the alternator.Inside the alternator.
the computer is behind the glove box 88-95
Under the drivers seat.
The ECM is located inside the vehicle. It is on the passenger side above the heater box.