If it is the 3800 engine, it is located behind the harmonic balancer on the front of the engine. You may need a special puller to remove the balancer. If it is the 2.8L engine. It is in the engine block between the engine blocks rt bank and the transaxle. It is very hard to remove this sensor. It has a tendancy to crack and break off which will force you to remove the oil pan to remove the broken peices.
Crank shaft sensor need replaced or cam shaft sensor
under the crank pulley, right side of car under front of engine
behind the crank shaft pulley. remove pulley and install new one make sure to replace it in the exact same spot it was before of you will tear up your new sensor
RIGHT SIDE OF ENGINE NEAR CRANK PULLY
I had the same problem check the crank shaft position sensor i payed maybe 25 bucks for one and its not all that hard to change with the right tools.
Where is the crank shaft sensor located in a Audi a6
One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
It is mounted on the throttle shaft usually on the other side from the throttle cables. It has a three wire connector plugged into it.
Crank shaft has rolled fillets, block is tapped for oil drain line from the turbo.
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
That year model does not have a crank sensor.