The pump and motor assembly can be found directly behind the back seat right in the middle. just pull up hard and fast on the front edge of the bottom part of the back seat and it should pop out. You may need to feel around with your finger tips for the two locations where it's actually attched and pry it up with a large flat blade screwdriver and it will easily lift out from there. Then you'll need to remove the (2) bolts that hold down the seatbelt bracket and lift straight up on the back rest section of the seat to remove it. You'll find the pump just behind the insulation right in the middle. It sounds like a lot, but it's really quite easy. kenito
A Chrysler Sebring does not have a reset switch.
Behind the back seat
Inside of the drivers side fender well.
It is under the dash on the driver side.
No.No.
On the 2.5L it is on the top rear of the bell housing.
No. The body changed after 2000.No. The body changed after 2000.
Yes
No
It is in the fuel tank.
Yes
It was not built with one.