Answersame problem I have.I think throtle position sensor and speed sensor can cause thise problem.try first any adjustment on throtle sensor then speed sensor. may be both wear out.A faulty ABS speed sensor can give you those symptoms. Just to eliminate the possibility, remove the ABS fuse and take it for a test drive. If the problem goes away you have found the problem.
Fuel speed sensor? Try again, need more info.
Did yOu ever find the speed sensor? What was the problem befor changing it
A bad transmission speed sensor will result in the transmission not shifting at the proper times. The defective transmission speed sensor may also cause the vehicle not to idle properly.
yes
if your code is po500 check the wires between speed sensor and cluster .mostlikely your problem is in the cluster
There are a host of reasons but the symptoms are not very detailed. 1) One reason could be low ATF fluid. 2) Bad speed sensor 3) Problem with A/T
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
Your gage may be the problem, if the vehicle is using a speed sensor then the input will go through the computer before it gets to the speedo. to answer the question directly, you need to get a manual on the vehicle and reference the wiring schematics in the back.
Some symptoms of a bad speed sensor are a speedometer that does not work or stops, a vehicle losing power unexpectedly, rumbling or idling of the vehicle, and transmission problems when trying to shift gears. The sensor has many functions in a vehicle, including ignition timing, fuel regulation, and the operation of cruise control.
IF the speedo does not work that means is not getting a signal from the output sensor. Also delayed and erratic and mushy are controlled by the input sensor speed battery level must be correct/ idle speed all this is to the battery of sensors opening and closing at proper perspective intervals.
Vehicles with ABS may have speed sensors at each wheel. If one of the wheel sensors has failed or if the connector has corroded or become damaged you may get a code indicateing a speed sensor problem.