does this happen when you want to reverse on a hill?, if so, the handbrake sensor thinks the car is slipping and keeps the handbrake engaged, so you need to manually release the handbrake by pulling it (exactly the same way as you engaged it)
Hope this helps
Robert
Wiki User
∙ 14y agothere was a recall for reprogramin18months ago check with dealer
Trip to the stealers Only..............
220Nm for Scenic, Grand scenic 280Nm
my parking brake release did not take off the parking brake on my 2001 chevy s10? is there a way to disengage it?
DOT 3
Put the card in, press the brake or clutch and press start
On the 05 model it is in the boot. Take out the board covering the spare and then you should see the release mechanism in the centre under the rear seats. With instructions on it.
Brake bleeding, clutch bleeding, coolant bleeding. You need to be specific.
There should be a parking brake lever above the parking brake pedal that you pull to disengage the parking brake. It depends on the type you have; if it is a pull-up lever in your center console they can give you a little trouble. Pull it up slightly and while you have upward pressure press and hold the button on the end, than it will drop.
hi i have problem with electric hand brake scenic 2004. the check lamp instiguish and code 182- redundant brake on switch internal electronic error don't disappeared. what can i do?
Put your foot on the brake, pu the car into drive and the parking break should disengage. if not, push on the parking break while holding the break in drive.
There are five steps on how to adjust the parking brake in a 2001 Ford Explorer. Some of the step-by-step instructions are park the vehicle on a flat surface, place the wheel blocks under both front tires, and disengage the parking brake.