On a Fiat Punto, the sump plug is at the base of the sump. It should be a hexagonal fitment and somewhere between 12-13 mm. .
The firing order for Fiat punto 1200 is 1,3,4,2.craig duggan where is number 1 plug
The firing order for fiat punto 1200 is 1,3,4,2.craig duggan where is number 1 plug
The spark plugs on a Fiat Punto are changed by removing the spark plug wire cover and pulling firmly on the plug wires. A deep wall socket can then be used to remove and replace each spark plug.
spark plug FR7DC2 set gap 0.9mm
Its a hexagonal fitment and should be 12-13mm
There is no dipstick for the gearbox the punto has a filler/level plug on the front of the gearbox 12mm Allen key fitting hope this helps best wishes Mike 2
fule cut off for a fiat grande punto active 77 59 reg dont pull your car a part like me if you look were the gears are you will see a box with two leads in it but be for you take it out take the batt off right ok you no were it is now that is a airbag ecu module look this up on ebay you can send them off to be reset for about £30 + 3 post now the fule cut off is in the ecu when you get it back plug in and now you can start up and drive it for the 1st time like me or you get your car back all the best 2 all thanks ian
Where is the diagnostic plug on fiat siena 1.2 el
where is the diagnostic plug located in a fiat stillo
There is a filler level plug, You'll need a 12mm allen key for that. It is located on the front face of the gearbox casing, next to the reverse light switch.
If it's an 8 valve engine and not the 16 valve: Bosch Spark plugs have a gap of 0.8mm NGK spark plugs need a gap of 0.9mm 16 Valve engines have a 0.9mm gap on each type of spark plug