How to reset maintenance info after oil change on benz c240
With the key in position 1, hit the odometer reset button on the left on the cluster 3 times in a row.
The cluster should beep once.
scroll through the multifunction display with the page buttons until the display shows the onboard voltage screen. It will say something like "UB: 12.2 V" scroll threw this menu with with the up/down until you reach the "service menu" page.
scroll down to "confirmation"
press +, confirm full service with +.
Wait till it says service confirmed.
cycle the key off and then back on to position 2. Scroll to the normal service menu where it normally says how many days or miles till next service. If the service was reset correctly, it will say "service display not possible" for a few minutes while it recalculates. You must cycle the key off and back on before it will back out of the onboard diagnostic mode. If you don’t back out, the esp/abs/bas lights will illuminate when the car is started.
On a 2005 e320 4matic, the battery is located in the trunk. It is in the rear side, next to the spare wheel.
how do you reset the check engine light on a 2005 Toyota tundra
How do i reset a service engine light on a 2005 gmc c6500 cat engine
One way to reset a 2005 Honda Element check engine light is to disconnect the battery. The battery will need to be disconnected for about 5 minutes for the light to reset.
You can reset the check engine light on a 2005 Honda Pilot by disconnecting the battery for a few minutes. If it comes back on, you need to take it to have it checked or reset by a mechanic.
disconnect the battery for five minutes, It will reset
wegfnfgm.aghjtk6k5
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
You need a scan tool to reset codes after repair.
when you disconnect your battery and reconnect it will reset cumputer
Two reset the maintenance required light on a 2005 Honda Accord all you have to do is hold the odometer reset button on the gage panel for about 30 seconds while the key is in the on position. Not running just in the on position. it will reset.
It is in the owners manual.