Remove the Sunroof inner cover by prying down the front. This will expose the underside of the sunroof. Remove the keeper from the shaft in the center front. This is the end of the cable. Activate the sunroof motor and the cable will be forced out the front. There is about 12 inches of solid shaft then the cable begins. It is messy! ! ! . When the cable stops moving out, pull it out with your hands. To install a new cable, grease it, slide the end down the tube until it stops, then press the motor switch and draw the cable into the feeder tube to a length appropriate to match up with the position of the sunroof cable mounting bracket, insert the cable and replace the locking pin.
With the power roof button. If its broken.... I heard there's a cable you can turn behind the trunk.. accessed from trunk.
My brother works for a Saturn dealership. He said if the fuses are good and the sunroof won't do anything it is the sunroof motor. If it moves a little bit it's either the cable or the rails. That's what the techs at the dealership told him.
You will have to remove the door panel and replace the regulator assembly. In some cases it comes as an assembly with the motor.
Check the modulator cable and the transmission pressure module. Adjust cable and clean or replace trans module. Cheers!
a broken cable you can order a new one at carpartsdiscount.com also check out the small plastic piece they call the motor.
Broken cable?
Blown fuse, glass off the track or the cable that runs from the sunroof motor to the glass has busted.
passenger seat cable its under seat drive cable
The speedometer on the 1985 Mercedes 230E is operated by cable. The 230E was in production from 1979 to 1985.
yes and they all have problems. its not the motor, or cables. its the plastic track where the cable attatch to that crack and fail.
Replace clutch cable on sportsbike
Here is what the shop manual says. 1. Drop the head liner. 2. Disconnect teleflex cable end from sunroof. 3. Press sunroof button to "open" to disengage cable from motor gearbox. 4. Remove cover in trunk on LH side and disconnect motor wires. 5. Disconnect teleflex tube. 6. Remove unit. If the cable is frozen you have to disassemble the gearbox on the motor assembly. If the motor is dead you can manually open and close the roof from the motor assembly. As a side note you may be able to disconnect the teleflex tube at the motor and just run the roof open to disengage the cable from the gearbox. This would keep you from having to remove the head liner. I have not tried this but I would try is first Hope this helps.