0
First of all, you need to make way from the driver side of the car so as to access the area just forward of the Throttle Linkage, remove anything that you can to give you more room, everything can be done from on top. Their is a special tool. You can make it like I did, get a 3/4 " combo wrench, heat and bend it about 2 " from open end of wrench to a 90 degree angle. On the box end end weld a very large (1 1/4 or so ) socket over the boxed end so that you can put a Breaker Bar 1/2 drive wrench on the socket. The replacement unit is 18 mm but the 3/4 will work to put the new one on.
Add your answer:
Earn +20 pts
How do you replace sending unit on a 2006 Chevy Malibu?
Need to know which sending unit you want to replace, there are several.
How do you replace The sending unit?
This depends on what sending unit you are speaking of. If it's a fuel sending unit, this is in the gas tank. You will have to drop the fuel tank to do this.
How do you replace sending unit 1994 Chevy 1500 5.7?
We need to know which sending unit you speak of. There are several on that vehicle such as temperature sending unit, oil pressure sending unit and fuel gauge sending unit.
How do you install fuel sending unit in 1995 Chevy S10?
how do you replace the fuel sending unit
How do you replace the fuel pump on a 1996 dodge avenger?
Drop the tank pull the sending unit and the pump is in the sending unit to swap u might have to replace the hole sending unit to be able to get the pump
Where is oil sending unit located on a 1993 Nissan sentra?
The 1993 Nissan oil sending unit is located on the bottom of the engine inside of the oil pan. You will need to remove the oil pan in order to view the sending unit.
Where is the Oil sending unit location 1993 olds achieva?
The oil pressure sending unit is located up on the head near the pulley for the power steering pump. It is on the back side of the head. I had to replace mine. It is an easy job.
How do you replace a fuel level sending unit in a 1993 Mercury Capri?
Remove the rear seat...You'll see the sending unit with the connectors(it's a metal plate)...Remove all the screws,unplug the connectors and hoses and the whole sending unit comes out in one piece....It's very easy//
Where is the oil sending unit on a 2000 Pontiac Bonneville and how to replace it?
where is the oil sending unit on my 2000 bonnieville
How do you change the fuel level sending unit on a 88 jaguar xj6?
Remove the rear light cell to expose the sending unit. All will be clear then.....AP
Where is oil pressure sending unit on 1993 crown Victoria ford?
The oil sending unit on 1993 crown victory is located right under the oil filter.
Where is the oil pressure sending unit for a 1993 Jaguar XJ6?
On the left hand side of the engine under the inlet manifold. Bolted into the block towards the front inline with the oil filter.
