1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.
how do you replace license pate light on 2006 pontia g6
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
you need to remove the inside panel to get to these bulbs
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
How do you change the liscence plate light fuse
same way you do
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
Superdiscount LEDs has a tutorial out how to change the license plate light to an LED light. Its pretty general how to do but a lot easier with pictures. Heres to step by step links that should help you! http://www.superdiscountleds-how-to-install-leds.webs.com/ -OR- http://www.go-audi.com/14083-audi-q5-how-do-i-replace-license-plate-bulbs.html Source: www.superdiscountleds.com
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.
if your under miles its under warrenty
To replace the license plate light on a 2005 Toyota Sienna, you will first need to locate the light housing on the rear bumper near the license plate. Next, you will need to remove the screws or clips holding the housing in place using a screwdriver or a trim removal tool. Once the housing is removed, you can access the old light bulb, twist it counterclockwise to remove it, and replace it with a new bulb of the same size and wattage. Finally, reattach the housing and secure it back in place with the screws or clips.