uneed to price of the black cover and undoo the whole of the door panel then where the wing mirror is you need to undo the 3 screews and itshould pop straight out
you have to go to a automobile specialist.
easy little wing nut in boot behind light undo it pull out and change
Can I fit Electric Folding Wing Mirrors on my Citroen C2 VTS, it has at present electric mirors but not folding, I have bought a set, with a new dashboard switch, is the wiring compatable, 2009 VTS.
Replacing the front wing on a Peugeot 307 you should find a replacement part and consult the cars manual. Line up the new front wing, bolts and clips.
Prise off internal plastic trim and undo 3 screws. Disconnect electrical connection. Reverse to replace.
Front Wing was created in 2000.
If it is after 1995 mark 4 it is easy bolt on, if earlier it needs cuttting and welding
Ok you will need to take the three bolts off from the top of your wing under the bonnet (not the two large bolts at the top as those bolts are for the bonnet arm). You will then need to take the three bolts from the side of the wing these can be seen when you open the door from behind the wing. The last bolt is at the front under the bumper (you shouldn
On a 205 gti, you have some bolts along the top of the wing(under bonnet shut line), also 2 or 3 along back side of wing(behind door shut), and then some mastik type stuff on inside of wing itself :)
It is located under the windscreen washer bottle which is located under the front offside wing (rhd)How to remove and replaceI searched the web to find this answer and couldn't so after an afternoon of doing it here goes!First, I jacked the front of the car up from the drivers side front mount. Then turned the wheels to the right (no need to remove wheel). I removed the inside inner arch enough to access the area. You then need to loosen the horn bracket...one bolt, you can then see the pump with the hoses attached...a gentle pull out will remove. Make sure your legs aren't there as it empties the water out when removing ( I got soaked!). Un clip the wires and replace...Not difficult, I managed to remove with a few spanners and a couple of Alan keys
remove wing mirror