check the switch on the top of the brake pedal.
under ure brake pedal u have a brake switch simple fix.
at the brake pedal behind or on top
P2299 : brake pedal position, apps sensor reading incompatible. Either the brake pedal switch, or the accelerator pedal position sensor (apps) is sending an improper reading to the computer. The other possible cause of this code is brake torquing the engine by holding the gas and brake pedals down at the same time.
The accelerator pedal has the sensor incorperated. It is replaced as a unit. Part # 30683516
These cars had issues with the pedal pressure sensor located in the brake booster. Additionally the brake booster it self is also known for failure on this car.
brake light switch is above the brake pedal under the dash
look on the brake pedal lever.
Check the sensor on the brake pedal arm.
Spongy brake pedal that can be pumped up to more solid pedal Brake fluid system has been opened for repair or part replacement Spongy brake pedal that can be pumped up to more solid pedal Brake fluid system has been opened for repair or part replacement
The reason it is stuck in park is because the brake pedal sensor is defective or intermittent. A solenoid will release the shifter when it receives a valid signal from the brake pedal assuring that the brakes are applied before allowing to engage any gear. Check to see if the stop lights are bright when the brake pedal is pushed. I have an on going issue with my pedal. It appears that after 200,000 miles the pedal does not fully return to the rear most stop to reset the sensor. I have found with some elementary troubleshooting the use of a bungee cord to assist in returning the pedal to it's aft most stop it has alleviated the problem until I can get the sensor replaced.
you do not adjust the brake lights check the bulbs or check switch top of brake pedal.