0
start by removing the shroud around the column. remove the assembly that houses the ignition switch, there is a spring catch located in the lock and tumbler, you will have to drill a small hole in the side to push this spring and while pushing the spring down rotate the switch and pull out.
Add your answer:
Earn +20 pts
How to Remove a 1998 BMW z3 ignition switch?
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
How do you remove the ignition switch on your 98' Chevy lumina ltz car?
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
How do you change ignition switch on 1998 Buick century Do you have to remove the steering wheel?
do I remove steering wheel to change out ignition
Remove ignition cylinder?
key switch tumbler removal on 1998 astro
Where is the drivers side power window relay located on a 1998 vw jetta?
The 1998 VW Jetta drivers side power window relay switch can be found inside of the drivers side door. You will need to remove the drivers side door panel in order to access the power window relay switch.
How do you remove ignition tumbler 1998 Ford Mustang?
How do you remove ignition tumbler 1998 ford Mustang?
How do you remove the ignition key switch on a 1998 Chevrolet truck?
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
How do you remove a ignition switch from a 1998 astro van?
One to repair an ignition switch on your Astro Van is buy a replacement steering column from a local salvage yard including the ignition key, and replace the whole steering column. RC Houston, TX
Where is the ignition control module in 1998 vw jetta?
Part of the coil mounted to the fire wall
Is there a kill switch on a 1998 dodge neon sport?
No, there is no kill switch except for the ignition switch.
How do you remove key switch Ford Contour?
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.
How do you replace the ignition switch in a 1998 Pontaic Sunfire?
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
