how i can removefront headrest for chevy suburban 2001
how can you reset the headrests after deployment
On the backside in the middle of the seats there is two buttons you have to push and then pull up the headrest. //Sam
Press into the fabric of the seat, immediately in front of the base of the headrest. This will release the catch, and the headrest can be adjusted up or down, or removed entirely from the seat.
On most cars theres a lever that you push and it can adjust hieght.But older cars no. 2012 Cruze has two types of headrest, the rear have a button release on BOTH posts in order to fully remove the headrest. The front headrest does not have a second button as it is not intended to be removed. HOWEVER ..... if you look closely at the side that does not have a button, there is a very small hole. Use a small allen wrench, slide it into the hole to release the locking mechanism. You must also hold in the button on the other side and pull up on the headrest all at the same time. The headrest will slide right out. Do not drive the vehicle with the headrest removed. I only needed to remove the headrest to install a seat cover.
Unzip back. Remove upholstry rings on the two bottom metal rods then slide the rear one half way out to fold it up. Remove rings holding middle metal rod. Push headrest halfway down. Slide a screwdriver up the front of the headrest post to keep the release lever from closing while removing the headrest. It is located behind the front seat foam. I have a 93 Lebaron GTC Conv
push pin in hole in plastic on bottom of head rest bar.
how do i remove the electronic front head restraint on a Mercedes c class
use a bat
OF course it can its the 21st century
Very carefully :)
Use a sledgehammer.