0
First remove the inside door handle (plastic handle that you pull the door closed with when sitting inside, not the handle that you pull to open the door). Once removed you will find 2-small bolts inside that need to be removed. After the 2-bolts are removed begin removing the panel by pulling around the edges popping the panel off its plastic posts which are behind the panel. If you can't get your hands underneath to pry the panel loose you can slide a flat-head screwdriver under the sides of the panel & pulling on the panel until you hear a popping sound. Do this until all posts are free. After they are all popped free you will have to lift the panel upwards to allow the door lock button at the top of the panel to pass through its hole. You will also find 2-wire harnesses behind the panel that you will have to release by squeezing the connectors & wiggling free. This will allow you to remove the panel completely.
Once the panel is removed you will find a dark gray foam (near the door lock at the top of the interior of the door) that you need to peel away from the metal portion of the door. It is held on by an adhesive so be careful to work your way along the sides so as not to tear the foam. This foam can be reapplied (without adding any additional adhesive back to it) after the job is completed. Reach your hand inside & you will find a "lever" that you pull down slightly & then slide to the left (if you are working on the passenger side door, slide to the right if on the driver side). This "lever" is held in place by a small spring that you will be compressing to slide the lever over. This process releases the outside handle so while holding the lever over to the side you will need to pull the outside handle outward (away from the car). You may need someone to help you with this although I have done it by myself so it can be done. Once you have released the outside handle in this manner you can pull it out by pulling it out as far as it will go & then maneuvering it out of the opening on the "hinged" side.
Hope this helps.
Add your answer:
Earn +20 pts
How do you remove the door panel on a 2004 tundra?
i have a 2004 Toyota tundra double cab i want to remove passenger door panel to tight door handle
How do you change a door handle on a 2004 Mitsubishi Endeavor?
To change a door handle on a 2004 Mitsubishi Endeavor, remove the 2 screws of the face plate. Then remove the 2 screws on the knob plate. Remove the door handle and replace with new.
How do you remove the console cup holder on a 2004 Volvo S80?
there are little screws and clips
Remove door handle 2004 Dodge Ram 1500?
First remove the door panelRemove the moisture barrier.Disconnect the rods from the handle inside the door.Next remove the two bolts holding the handle on.
How do you replace the outside door handle on the drivers side of a 2004 Silverado?
with a screwdriver
2004 X5 driver Outside Door Handle doesnt work Inside handle OK?
Remove interior door panel. Check the rod from the latch to see that is attached to the outside handle. Reattach rod. The rod clip made may need to be replaced if it doesn't hold. This condition can be caused by someone breaking in or it was serviced and not installed properly.
How to remove the inside door panel of a 2004 Hyundai Elantra to fix the inside handle?
1. On manual windows remove the crank handle by dislodging the clip 2. Remove the outside mirror cover 3. Detach the door handle trim piece and disconnect the linkage rod. Remove the door pull mounting screw. Unplug the electrical connector from the power window switch 4. Remove the retaining screws and detach the panel by carefully prying it away from the door. Remove the screw concealed behind the armrest and one behind the door handle. Pull the panel upwards to remove it 5. For access to door outside handle raise the window fully remove the power window control unit the door panel bracket and speaker then carefully peel back the plastic water shield
How many valves does the 2004 Volvo XC70 have?
The 2004 Volvo XC70 has 20 valves.
How many valves does the 2004 Volvo S80 have?
The 2004 Volvo S80 has 20 valves.
How many valves does the 2004 Volvo S60 have?
The 2004 Volvo S60 has 20 valves.
How many valves does the 2004 Volvo C70 have?
The 2004 Volvo C70 has 20 valves.
How many valves does the 2004 Volvo XC90 have?
The 2004 Volvo XC90 has 20 valves.
