slacken wheel nuts. raise car and remove wheel
Slacken and remove ball joint through bolt at the bottom of the hub carrier.
Remove nut from middle bush then pull out the long bolt.
INside car, lift carpet back, under a cover in the rubber soundproofing you will see two nuts, slacken and remove them, dont lose the washers.
check ball joint is free and prise it downwards from the hub carrier
remove bolt from middle bush and drop wishbone to the ground. Mind fingers - its quite heavy.
Replace inopposite order but dont tighten any bolts until its all inplace then do them up tightly.
Care! Support vehicle properly and make sure driveshaft doesnt pop out of the gearbox and cover you/floor with oil.
If it all sounds too difficult get it done at a garage - it only takes 30 mins :-)
you have to take the complete wishbone off to press out ball joint
remove water pump on saxo 1.4
Citroen Saxo is drived from french.
top speed of a Citroen saxo 1,1
were are spark plugs in citroen saxo
Change password for the start engine for citroen saxo?
what about it?
citroen saxo 1.4. what is the rear brake hub torque setting?
You can not, the hub is part of the suspension strut itself.
are u thick?
5,8l
citroen saxo steering conversion