with alot of money
easier to do with gearbox still in place :)
Try Gearbox End next to pavement visable thru wheel ach poss.
Hi there is a 24mm bolt on the gearbox on the under side. And then put the new oil in by the dip stick.
it has not got one you have to remove gear box sump plate
Zafira 2.0Ltr DTI 16V from January 2003 onwards Engine code Y20DTH Gearbox code F23 Has a dual mass flywheel fitted.
You have to remove the engine and gearbox. you will need a engine crane. Once you have the engine and box out, remove gearbox from engine and replace clutch, Refit gearbox to engine, put engine and gearbox back in car. Easy job if you have access to a engine crane.
if its flywheel all car will shake/vibrate when you accelerate have had my zafira diagnosed at vauxhall they quoted over £1300 try cleckheaton clutch specialist in Bradford
Yes but you will just wined the diffs up in the gear box
remove either engine or gearbox from the car , in the gearbox undo the 3 torx bolts that hold the bearing in place ,spin it round ,undo the little clip holding the pipe together and then remove bearing ,this is the slave cylinder. refit is reverse of removal ,note the rubber seal that fits on the end of the little pigtail pipe if not on then the whole thing has to be repeated so check before refit .
5 as far as I know. Vauxhall Zafira energy Vauxhall Zafira elegance Vauxhall Zafira life Vauxhall Zafira comfort Vauxhall Zafira design
Other than it being a transmission & gearbox out job, I don't know, but that's what is needed as the slave cylinder is apparently INSIDE the bell-housing.