On the bottom left of the instrument cluster, is a button marked 0. Switch ignition on and immediately press the button. Switch ignition off. Press and hold the button while switching the ignition on. After 10 seconds, the new interval will appear, accompanied by a beep. Release button. Switch ignition off.
When the service indicator light is illuminated, hold down the scroll button. The service display will return to 100 percent and the indicator light will off.
how to turn off the service light
The service indicator light, in your Mercedes ML 270, can be reset by holding in the engine oil life button. The engine oil life will go to 100 percent. The service indicator light should go off.
To reset the service indicator. Switch off the ignition. Push and hold the mileage reset button (on the right) switch on the ignition (whilst still holding the button) the display will count down from 10 to 0 when it reaches 0 let go switch off the ignition and switch on the indicator should now be reset.
On a Renault Clio washed car but Rear indicator lights still on and can't turn them off?
the service light will go off after a number of miles..... I believe mine went off after 100 or 200 miles
with the switch off, press and hold the odometer button. Turn the switch on, and the odometer will be in insp mode. mode. Press the odometer button until the indicator shows --- . Turn the switch off and the lamp should be reset.
To reset the service indicator. Switch off the ignition. Push and hold the mileage reset button (on the right) switch on the ignition (whilst still holding the button) the display will count down from 10 to 0 when it reaches 0 let go switch off the ignition and switch on the indicator should now be reset.
Service indicator reset switch ignition to position 2 press brake & accelerator pedals together for 15 seconds service indicator will flash when reset release pedals turn ignition off hope this was useful Mike 2
Hold in the wrench button on instrument cluster, and at the same time turn your key forward (without starting). While still holding the "wrench" button in, press the "0,0" button and hold until the "SERVICE!" notification clears (about 2-3 seconds). "Service!" Indicator Reset Procedure/Service Indicator Reset Complete!
If its due to you reaching your service interval, you can reset your service indicator by doing the following: - turn the ignition on - press the left button on the side of the speedometer two times to display the service interval indicator - when it appears, push and hold the left button, then while holding the button down turn the ignition off - now while holding the button down still turn the ignition on and hold the left button further for 10 seconds - release the button and this should now reset the service indicator If its not the service indicator and if you don't do the service with the above reset its not a good idea to do the above as it might make the next service level much higher and also can cause warranty issues if you don't get servicing done. The above is to allow people who service the smart outside of a smart dealership the chance to reset the indicator.