Were can I buy a throttle cable for a 97 geo metro
It is on the side of the throttle plate right across from the accelerator cable.
I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.
The TPS (throttle position sensor) would be found on the throttle body, opposite side the throttle cable is attached to.
Depends on the type of engine fitted on the Peugeot 306. For the TU3JP engines, KFX modification (that is 1997 - 2000 year make, I think), it is in the throttle and the connector right under the TPS sensor (again in the throttle body area).
The throttle plate is inside the throttle body on the intake manifold. The throttle cable from the accelerator peddle is connected to the throttle plate shaft on the throttle body. If you remove the air cleaner hose at the throttle body, you will see the disc shaped plate.
how do you change the handbrake cable on a 1997 Toyota rav4
There is no Cable it is a speed sensor on the transmission
You can't adjust the TPS, but there is a way to adjust the idle if thats what you want. Right next to the brake master is the throttle cable and with your fingers spin the black plastic nut on the cable to desired rpm.
back of air intake opposites to cable under breather
clutchs in tranny are going bad, bye a new or remanufactured tranny to put in it, it is better than haveing it rebuilt It could also be the spring on the throttle valve being broken or installed in corectly. It is mounted on the side of trans. follow the cable from throttle body to transmission the spring should pull on the lever away from throttle body. ot he cable is not ajusted properly. look for ajustments for the tv "throttle valve"cable.
on the throttle body on the throttle body