YES IT CAN BE DONE. MOVE THE MIRROR THE THE FAR MOST DOWN POSITION AND UNCLIP IT FROM THE BACK OF THE MIRROR AT THE TOP. (THERE SHOULD BE A SILVER SPRING TYPE CLIP). MOVE MIRROR UPWARDS WITH HAND AND REMOVE. REVERSE ORDER TO INSTALL.
The signal lights on a 95 Mercedes e420 is changed by removing the retaining screws and pulling the light away from the vehicle. The bulb can then be disconnected from the wiring harness, unscrewed from the housing, and a new bulb put in place.
The thermostat on a 2001 Lexus RX300 is replaced by removing the upper radiator hose and unbolting the thermostat housing. The thermostat can then be removed, a new gasket installed, and the replacement thermostat placed in the housing.
The heater core can only be accessed by removing the dash and HVAC housing.
Their are 2 batteries on this vehicle. The main battery is in the trunk under both false floors near the spare tire on right side . The small sbc battery is under the hood. Under black air cleaner housing on passanger side firewall. this is held in place with one 10MM nut. battery is right under this housing.
The computer on a 1999 Aurora can be replaced by first disconnecting the battery and removing the wiring harness to the computer. It can then be unbolted from its housing and a new one put in place.
on the passanger side. it i located on the trans housing where the engine and trans meet.
The heater core on a 1999 Ford F250 Superduty is replaced by removing the heater hoses, disconnecting the wiring harness, and removing the retaining bolts. The cover can then be removed, the heater core unbolted, and removed from its housing.
very carfully
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
The thermostat on a 2004 Chevy Venture is changed by draining the radiator, removing the upper radiator hose, and unbolting the thermostat housing. The old thermostat and gasket can then be removed and replaced.
This is sort of a difficult job. The black housing under the hood (on the passanger side) has to be removed. The heater core is mounted inside that housing.
Below the head, passanger side, sticking out forward from the transmission bell housing.