The problem here is that you may encounter high voltages in the power supply. So wearing an antistatic wrist strap may put you at a greater risk of electric shock. Besides, there are few if any sensitive electronic components inside the power supply unit.
In addition, make sure the power supply is not connected to any power before servicing it. If you need to go near any large capacitors, you will want to discharge them. In fact that is a good precaution to take any time you remove the circuit board from the power supply unit.
DC Power is Direct Current Power Supply.
That would depend on the power supply.
ferro-resonant power supply?
Uninterruptable Powersupply
ohmmeter has it's own power supply
No attempt should be made to repair the power supply. The power supply should be replaced with a power supply of equal or greater wattage.
A computer's (PC's) power supply is a sealed unit and should be replaced as a whole - It is dangerous to try and repair the inside of that sealed unit (that is why it is sealed).
It would be safer and to purchase a new power supply,a repaired power supply might pose a fire hazzard.
Electricity hurts
The drive appears to be a bad one. Why do you need a floppy disc drive anyways?
any power supply with at least 175 watts
No, but they are usually not worth the trouble.
It sounds like you have a power supply problem. The capacitors on the switched mode power supply have changed value or failed completely. Replace or repair the power supply section.
infact i think the power supply be replaced with new one. infact i think the power supply be replaced with new one.
The type of power supply being used (AC or DC) should match the power requirements of the device it will be supplying power to.
Remove and replace the power supply.
If you are supplying power in vehicle or base station (using a AM-7239/VAA) it is suggested that 24Volts & 5Amps. The same type of power supply could be used in a repair shop.