answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why sawtooth waveform is used in thyristor triggering circuit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can a conducting thyristor be turned off?

A conducting thyristor can be turned off by reducing the current flowing through it below the holding current value. This can be achieved by interrupting the current flow using a circuit breaker, reverse biasing the thyristor, or triggering the thyristor with a gate signal that transitions it into a non-conducting state.


How to generate sawtooth waveform of 0 to 5V from square wave of 0 to 15V...?

You will need a regulator circuit that will change the shape of the pulse AND regulate the voltage to 5v.


What is the thyristor firing circuit?

The thyristor is basically used a switch in an AC circuit to control the amount of power fed to the load. To turn on this switch an "electric" pulse should be applied to the Gate terminal of the Thyristor. A circuit which supplies the "electric" pulse is called the firing circuit.


What is ocillating?

In electronics, it is a circuit which repetitively produces a certain output. This may be a series of pulses or a repetitive waveform such as sine, sawtooth or ramp. In mechanics, a pendelum is an oscillator. An oscillator is the series and parallel combination of resistors and capacitors.


What does forced commutation mean?

The term "Forced commutation" is used when a thyristor is turned off using external components. If a thyristor is used in a DC circuit, when first turned on, it will stay on until the current goes to zero. To turn off the thyristor it is possible to use a Forced commutation circuit. The circuit creates a reverse voltage over the thyristor (and a small reverse current) for a short time, but long enough to turn off the thyristor. A simple circuit consist of a precharged capacitor and a switch (e.g. another thyristor) parallel to the thyristor. When the switch is closed, the current is supplied by the capacitor for a short while. This cause a reversed voltage over the thyristor, and the thyristor is turned off.


What type of op-amp circuit should be selected to change a triangular waveform into a rectangular waveform?

A differentiator


What is a line commutation?

it is the natural commutation ...by making open circuit or short circuit on the thyristor to make it turn off.


What is thyristors?

A thyristor is a part of a alarm circuit you use it so the alarm stays on


Why UJT triggering circuit is superior?

DPE?


Is there a difference between edge triggering and pulse triggering?

Yes, there is a difference between edge triggering and pulse triggering. Edge triggering occurs when a circuit changes state based on the transition of an input signal (e.g., from low to high or high to low). Pulse triggering, on the other hand, involves triggering a circuit based on the detection of a specific pulse width within the input signal.


Is IC555 is an ac device or dc device?

it is DC powered, but can generate sawtooth or triangular wave AC if wired up properly. it cannot generate sine wave AC, although with an opamp wave shaping circuit the triangular AC waveform can be reshaped to a rough approximation of a sine wave.


What circumstances led to the invention of the transistor in 1947?

before the invention of transistor,thyristor was used instead of transistor but thyristor produces more heat in the circuit and size is more when compared to transistor