If you are placing more than one resistors in series, then its combined resistance is higher than when you place these resistors in shunt.
In long shunt the shunt field winding is in parallel to both generator and series field. In short shunt the shunt field is in parallel to generator only.
An ordinary amplifier can have high gain but is unstable, drifts, can oscillate, etc. An amplifier with negative feedback has lower gain but is stable, does not drift, won't oscillate, etc.
The voltage is adjusted with a potentiometer that adjusts the field voltage through the voltage regulator.
aster
Basic voltage regulators are classified as either SERIES or SHUNT, depending on the location or position of the regulating element(s) in relation to the circuit load resistance.
advantages and dis advantages of shunt regulator
wala... secret In general the difference between series and shunt (or parallel) is that series is like a string of pearls, each one receives from a leading source and sends directly to a draining target (the current has to flow equally through all). Parallel however is like a railroad track in that the source is one rail and the drain is the other rail with each of the ties pulling from one and pushing into the other regardless of what any of the other "ties" are doing (each has a completely separate current flow from the others). In terms of regulation a series regulator would have to "block" some of the power going through it to the load in order to regulate it. A shunt or parallel regulator would have to "drop" or waste enough of the limited available power to restrict what would be left available to the load (or loads). Hope this overview helps
If you are placing more than one resistors in series, then its combined resistance is higher than when you place these resistors in shunt.
series controller, shunt controller,series-shunt controller,series-series controller
The circuit is designed so that at maximum load current the shunt regulator draws virtually no current and at minimum load current, the shunt voltage regulator passes the full current. As a result, it can be seen that shunt regulators are inefficient because maximum current is drawn from the source regardless of the load current, i.e. even when there is no load current.
In long shunt the shunt field winding is in parallel to both generator and series field. In short shunt the shunt field is in parallel to generator only.
An ordinary amplifier can have high gain but is unstable, drifts, can oscillate, etc. An amplifier with negative feedback has lower gain but is stable, does not drift, won't oscillate, etc.
shunt field winding have more resistance than series field winding ************sai ganesh ************269*******
It depends on whether the capacitor is series or shunt. If series, capacitors block low frequencies. If shunt, capacitors block high frequencies.
The voltage is adjusted with a potentiometer that adjusts the field voltage through the voltage regulator.
The ductus arteriosus is a shunt between the pulmonary and aortic trunks in the fetus. This shunt normally is closed at birth.