The combined resistance will be 2 Ohms.
86k. Resistance in series is the sum of the individual resistors.
In simple way resistor bank contains number of resistors in series or parallel combination. They are connected in parallel to decrease the resistance and increase current rating and power dissipation.And they are connected in series to increase resistance and power dissipation.
16 ohm, R1 + R2+R3 = RT in series.
Resistors are rated in wattage so the lowest wattage rating will be the wattage of the series circuit. It will be able to handle that power any more and the lowest wattage resistor could be damaged and fail.Another AnswerWhen two or more resistors are connected in series, the resistor with the lowest resistance will operate at the highest power. If the power developed by a resistor exceeds its rated power, then the resistor may burn out.
The same as what? when an inductor is connected in series with a resistor and a current passed through them, the voltages across the resistor and inductor are equal when the reactance is equal to the resistance: 2.pi.f.L = R
The net effective resistance of resistors in series is the sum of the individuals.Combined resistance = (100,000,000) + (10) = 100,000,010Ωhms.
Two resistors connected in parallel are 1/2 the sum of their resistance. The resistance of two resistors connected in series is the sum of their resistance. For example: The total resistance of a 100 ohm resistor connected to a 200 ohm resistor in parallel is 100+200 divided by 2 = 150 ohms. The total resistance of a 100 ohm resistor connected to a 200 ohm resistor in series 100+200= 300 ohms.
86k. Resistance in series is the sum of the individual resistors.
The net resistance of two resistors connected in series is the sum of the two resistances. RSERIES = Summation1toN RN
the voltage across that resistor will increase if it is in series with the other resistors. the current through that resistor will increase if it is in parallel with the other resistors.
In simple way resistor bank contains number of resistors in series or parallel combination. They are connected in parallel to decrease the resistance and increase current rating and power dissipation.And they are connected in series to increase resistance and power dissipation.
If the resistors are in series, then the total resistance is simply the sum of the resistances of each resistor.
16 ohm, R1 + R2+R3 = RT in series.
If two identical cells connected in series or parallel send the same current through a 2 ohm resistor, then the internal resistance of each cell would be 1 ohm. This is because when connected in series, the total resistance seen by each cell is 1 ohm, meaning half of it comes from the internal resistance of one cell. The same logic applies when connected in parallel.
Multimetres are generaly used to measure the following quantities. Voltage: multimeter is connected in parallel with the Load; Current: multimeter is connected in series with Load; Resistance: the resistor must be taken out of the circuit first, then, the probes from the multimeter are connected across the resistor,
A set of resistor connected in series causes 2ohm resistance since Req=R1+R2 and when connected in parallel it causes 0.5ohm since Req= (R1xR2)/(R1+R2)
Divide the voltage