answersLogoWhite

0


Best Answer

Soldering usually applies to electronics, but can be used in many different applications. Soldering in electronics is done by melting solder (in this case, a small hollow wire made up of 40 percent lead and 60 percent tin), which contains rosin (flux) in the hollow core. The purpose is to secure the electronic parts to the circuit board.

Desoldering is a removal of the solder already used, to release the parts from the circuit board so that a replacement part can be installed and soldered into place again.

I do it all the time as a matter of course and I can tell you first hand, it's not rocket science. Knowing the difference between a good solder connection and a bad connection when you're through isn't hard, but most hobbyists usually don't pay that much attention to the quality of the joint.

User Avatar

Wiki User

βˆ™ 9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the purpose of flux in the soldering process?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the purpose of flux and state the importance of cleanliness of metals when soldering.?

Gd


Why is flux required for soldering?

flux acts as a wetting agent in the soldering process, reducing the surface tension of the molten solder and causing it to better wet out the parts to be joined.


What is the purpose of borax in soldering?

Borax is used as a flux in soldering to clean the metal surfaces being joined and to prevent oxidation during the soldering process. It helps the solder flow more easily and create a strong bond between the metals.


What is the purpose of a flux?

The purpose of flux is to clean oxides from metal surfaces to ensure a clean bond in soldering or brassing them together. without a proper flux soldered and brazed joint integrity is unreliable.


What is the difference between flux and soldering paste?

Flux helps promote soldering. Soldering paste might contain flux and other items to help promote soldering. The paste helps hold the flux in place while beginning to solder.


Method of using expired liquid flux Soldering?

It is not recommended to use expired liquid flux for soldering as the effectiveness of the flux diminishes over time, which can lead to poor soldering results. It is best to use fresh flux to ensure proper soldering and avoid issues such as weak joints or oxidation. Expired flux may also contain harmful chemicals that could pose health risks during soldering.


Why should flux be used when soldering?

Flux is used when soldering to remove any oxidation on the metal surfaces being soldered, ensuring a clean and strong bond between the solder and the components. It helps the solder flow more easily and uniformly, improving the overall quality of the solder joint. Additionally, flux helps prevent new oxidation from forming during the soldering process.


Why borax is used in soldering flux?

Borax is added to soldering flux to help clean the metal surface by removing oxidation and impurities. It promotes good wetting of the metal by the solder, helping it flow smoothly and create a strong bond. Borax also helps to prevent further oxidation during the soldering process.


What is the purpose of soldering?

Soldering is the process of using a bubble of hot metal to bond two electronic components or circuits together.


What is the purpose of a flux and state the importance of cleanliness of metals when soldering?

Flux is used in soldering to clean metal surfaces, prevent oxidation, and facilitate the flow of solder. Cleanliness of metals is important in soldering because any contaminants on the metal surfaces can prevent the solder from properly adhering, resulting in weak or unreliable connections. Ensuring the metals are clean before soldering helps to achieve strong and reliable joints.


What is flux and in which operation is it used?

Flux is used to prevent oxidation while soldering wires and components in electronics.


Is flux in solder?

Yes, flux is a material commonly used in soldering to clean and prepare the metal surfaces being joined. It helps remove any oxide layers, promotes better wetting of the solder to the surface, and enhances the overall soldering process by ensuring a strong bond between the materials.