A race condition is a situation where the input setup and hold times for a circuit are not met. This results in uncertainty as to the final output. An example might be turning off the bus drivers using the same signal that you expect to latch the data with. You could see this with an oscilloscope or a waveform analyzer. You can also find it analytically, by studying the design.
A race condition or race hazard is a flaw in a system or process whereby the output and/or result of the process is unexpectedly and critically dependent on the sequence or timing of other events. The term originates with the idea of two signals racing each other to influence the output first. Race conditions can occur in electronics systems, especially logic circuits, and in computer software, especially multithreaded or distributed programs.
A race condition can occur where a resource that was being waited upon by two data structures/processes is released and both processes try to access it simultaneously. It can also happen where the processor has to assign a unique process ID to two processes that have created at the same time.
it impacted the society by making us put it out as a sport people race hovercrafts around also, they are very dangerous
it can be eliminated by using not more than two level of gating. ANSWER: It can be eliminated by using grey code whereby there is only one transition of state before any other can occurs
No
In Race round condition gate operation delay by signal but gate oprate first with clock ,this condition called the race raund confident
by using master slave flip flop
By using a master-slave J-K FF.
The "Race Around Condition" occurs when J+K=1 i.e. When the FF is in the toggle mode.the race around condition in JK latch can be avoided by:a) Using the edge triggered JK flip flop.b) Using the master slave JK flip flop.
Any race because it is a skin condition
A race condition is an undesirable situation that occurs when a device or system attempts to perform two or more operations at the same time, but because of the nature of the device or system, the operations must be done in the proper sequence in order to be done correctly.
RACE AROUND CONDITION OCCURS WHWN BOTH THE INPUT ARE HIGHAND THE OUTPUT THUS UNDERGOES A TRANSITION STATE.FOR EXAMPLE CONSIDER THE INPUT VALUES IN A JK FLIP FLOP;ie;J=K=1 ,THE OUTPUT Q0=0 IN NORMAL CASE WILL CHANGE TO 1 AND VICE VERSA. THE REMEDY FOR RACE AROUND PROBLEM CAN BE ELIMINATED BY USING A MASTER SLAVE J-K FLIP FLOP'S
two or more processes are reading or writing some shared data and the final result depends on who runs precisely when, are called race condition.
Race Around the World was created in 1997.
Around the Bay Road Race was created in 1890.
No albinoism is a condition in which the pigment melanin is absent from the body.