current flows as a result of potential difference i.e. in a circuit if there is no voltage difference between two points, no current can flow between those two points. So voltage has to be produced first.
Wiki User
∙ 13y agoWiki User
∙ 13y agovoltage produces current...its is the difference between the potentiaL which is causing the carges to flow between the two points
The first thing you need to know is the internal resistance of the current source, the voltage source will have the same internal resistance. Then compute the open circuit voltage of the current source, this will be the voltage of the voltage source. You are now done.
No, There can't Be current without voltage
Since power is current times voltage, doubling current while keeping voltage the same will double the power. Ignoring slight non-linearity, if the power doubles, the heat will double.
Voltage attempts to make a current flow, and current will flow if the circuit is complete. It is possible to have voltage without current, but current cannot flow without voltage. The answer is "yes",voltage remains the same as current moves through the circuit.As the voltage remains constant, current increases in the circuit.
Power = (current) times (voltage)Current = (Power) divided by (voltage)Voltage = (Power) divided by (current)
Voltage is responsible for the production of current. voltage is the unit of electromotive force which gives the electrons a motion in a definite direction which we call current. voltage can exist without current(i.e. in open ckt.) but current can not without voltage.
The reason an AC voltage applied across a load resistance produces alternating current is because when you have AC voltage you have to have AC current. If DC voltage is applied, DC current is produced.
There is no such thing as an 'induced current'. Voltages are induced, not currents. If a voltage is self-induced into a coil, then that voltage will oppose any change in current. If a voltage is mutually-induced into a separate coil, no current will flow unless that coil is connected to a load.
Alternating current is produced by generators or power plants that use magnetic fields to induce voltage and generate electricity. This type of current changes direction periodically, typically in a sinusoidal waveform.
The first thing you need to know is the internal resistance of the current source, the voltage source will have the same internal resistance. Then compute the open circuit voltage of the current source, this will be the voltage of the voltage source. You are now done.
For a current to flow between two points, those points must have a potential difference (voltage) across them.
A resistor is connected in series with a practical voltage source in order to determine the current produced by the source.
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
The current produced by a 1.5V flashlight cell would be lower than the current produced by a 12V car battery. This is because current is directly proportional to voltage in a circuit with constant resistance, following Ohm's Law (V = IR). Therefore, the higher voltage of the 12V car battery would result in a higher current compared to the 1.5V flashlight cell.
depending on the stray capacitance it can be from a few ten volts to a few kilo volts.
Neither, it is current that kills.