Here is the formula, Per hour consumption = Diesel consumed / Total DG run hours Diesel consumed = Previous closing balance - Actual closing balace Daily DG run hours = (Total DG run hours / (DG capacity*24 - Total DG run hours)) * 24 / (( Total DG run hours / ( DG capacity * 24 - Total DG run hours )) + 1 Regards, Shibin shibin.hesel@gmail.com
I assume you are asking about AC generators. The controller is wired up with suitable transducers and other control wiring to obtain required signals from the electrical bus. Three DG sets are feeding the common bus bar through isolating breakers. Conditions for a successful synchronization are equal voltage, equal frequency (Hertz) defined by the speed, same phase sequence. (say R Y B phases must match with R Y B of the incoming DG set) One DG is started with some load (at least 60 to 70 % of load) and the common bus is energized. The second DG to be brought in by closing the breaker either manually or automatically. Start the second DG. The controller reads the bus parameter and incoming DG parameter in real time and moment the incoming DG parameters match with running DG parameters, controller allows the incoming breaker to close. Both DG are now synchronized and load is shared. Same way put on third DG set and synchronize.
Actually safety devices of generator depends on the type of prime mover used in generator. The main safety devices in a DG Set is to control the over speed, to limit the fuel supply in case of emergency. It is regulated by the governor of the DG Sets. In external safety, over voltage & over current tripping relay i.e. associated with DG Sets control panel.
The function of a governor in a generator set is to regulate the speed of the engine. It works by controlling the fuel flow to the engine, adjusting the throttle settings, and maintaining a constant speed regardless of the load demand. The governor ensures that the generator provides a consistent and stable output frequency and voltage.
2
Which one is correct dG(x-0)-dG(x+0)=-1/p(t) or 1/p(t)
Which one is correct dG(x-0)-dG(x+0)=-1/p(t) or 1/p(t)
the function of a governor is to limit the rpm of an engine. it works by limiting the amount of fuel allowed to go into the combustion chamber
DG
fgdf fgd gdfg dg dg dfg dfg dg dg dfg dd
Spain
Spain
dg,gedg,dcbbcdgab dg,gedg,dcbbcdgab fbgffeefeeafeedded dg,gedg,dcbbcdgab bcdgaddcdgbg dg,gedg,dcbbcdgab dg,gedg,dcbbcdgab fbgffeefeeafeedded dg,gedg,dcbbcdgab bcdgaddcdgbg
The answer is .033 dg.
58,000 dg
4 dg
74.8 dg to kg